Brother FAX-2000P - Manual (Page 131)

Parameters for Recording (Printing) Unit
How to Set the Standby Time for the Printer (Power
Saving Mode)
The recording unit of the FAX-2000P uses a heater as an image fixer.
Most of the power used by your Brother FAX is consumed by the fixing
heater. Therefore, it is economicai to turn off the heater when your
Brother FAX is not in operation. The duration that the heater is turned off
is known as the power saving condition.
You can set the time before the machine enters the power saying
condition. Maximum time is 999 minutes.
D
2
In Standby mode, press FUNCTION, 0,9 and ENTER.
Press 2,2 and ENTER.
9.User Settings
01-12 Eriter/Sel ect
1 .Set Phone Type
01-25 ■ Enter/Select
22.Printer on time
01-25 Enter/Select
^ Enter the time in minutes through the keypad, then press
¿3 enter .
If 000 (Factory setting) is set, the recording unit will not
enter the power saving condition. All pages of the
documents received during the power saving
condition will be stored in memory before printing.
Therefore, it is recommended for you to set the time to
000 when your FAX has not enough memory to receive
a large amount of document in a single reception.
How to Set Page Separation Function and Reduction Rate
Page separation: If the received message or copy is
larger than the recording paper, excess
image is recorded on separate pages
when it exceeds a predetermined value.
Reduction Rate: To avoid page separation, received
messages and copies can be printed in
a reduced size. (90% default)
119