AquaCraft Top Speed 3 - Manual (Page 8)

8
RADIO BOX ASSEMBLY
FOR THIS STEP YOU ARE GOING TO NEED:
➧ Medium CA glue or 12 minute Epoxy
➧ #1 Phillips screwdriver ➧ 1.5mm hex wrench
➧ Moto tool with cut off wheel ➧ Hobby knife
➧ Household cement or silicone sealer ➧ Pliers
➧ Hand drill with 1/16" and 5/64" drill bits
With the switch mounting feature towards the starboard
side (right side of the box when viewed from behind), glue
the servo tray onto the standoffs inside the radio box.
Install the two waterproof boot mounting plastics
by sliding them in from the inside of the box.
Use medium CA to glue them in place.