Final checks and setup – AquaCraft Top Speed 3 User Manual

Page 18

FINAL CHECKS AND SETUP

Position the lower unit into the slot on the set up board.

Using a small machinist rule (you can get one at your local

home store), adjust the engine so the distance between

the boat stand and the bottom of the cavitation plate are

30mm at the front and 28mm at the back. This will get you

close in both the height and tilt for your fi rst test runs.

Having completed this, remove one engine mount bolt

at a time and place some silicone sealer on the bolt and

re-install it. Do this with all 4 engine mount bolts.

Place the provided foam into the bottom of the radio

box and insert the receiver battery pack. Place the

receiver in the box as well. Do your best to place the

receiver so as not to stress the servo plugs.