AquaCraft Top Speed 3 - Manual (Page 15)

15
Using a moto-tool and cut off wheel, cut the stainless
throttle cable 20-3/4" (527mm) long. It’s best to place a
short length of masking tape over the cable and place the
mark on the tape. Cut the mark with the tape in place.
Slip the short length of fuel tubing over the
cable and up to the metal clevis.
Next slide the cable into the white outer housing; as you
do this, get ready to guide the cable through the screw
lock connector (do not tighten the connector).
Attach the metal clevis to the throttle arm of the engine
and slip the silicone tubing over the metal clevis.