AquaCraft Top Speed 3 - Manual (Page 19)

19
Detach the servo arms from the top of the servos and
turn the radio system on. Adjust the steering arm to
center and the throttle arm to the position shown in the
photo and re-install the arms and servo arm screws.
Check the direction of both the steering and throttle
movement. NOTE: The throttle arm will move forward (front
of boat) to open the carburetor. Adjust the lock collar on the
steering arms so the engine is centered with the steering
wheel in the center position. Tighten the lock collars.
With the metal clevis attached to the throttle arm,
make sure you are getting a full range of motion.
GrimRacer Says: Adjusting the throttle
can be a tad more diffi cult so please
follow along closely. IMPORTANT:
After you have the throttle movement adjusted, you are
going to want to glue the white outer cable housing to
the rubber seal as it exits the radio box. The two must
be secure to maintain the throttle adjustment.
Make sure the carburetor barrel can fully open as
well as fully close.NOTE: If you are not getting a full
range of motion you might need to loosen the set
screw (1.5mm hex wrench) on the carburetor arm and
reposition the arm on the barrel of the carburetor.