AquaCraft Top Speed 3 - Manual (Page 13)

13
Install the screw lock connector onto the servo arm
with the one remaining spoke. Slip it onto the servo
for safe keeping. At this time it’s a good idea to loosely
install the servo arm screws so as not to lose them.
Next we are going to install the throttle cable. Begin by
cutting the white outer housing to 17-1/4" (438mm)
long. Next take the remaining small rod seal and
remove half of the pointed end with a sharp knife.
Slip the outer housing through the seal, positioning it about
2-1/2" (64mm) from the opposite end of the housing.
Glue the seal in the radio box, being careful not to get
any glue on the white outer housing. We are going
to adjust the position and glue the housing to the
seal later in the setup portion of the manual.