AquaCraft Top Speed 3 - Manual (Page 10)

10
Screw the switch in place; do not overtighten the screws.
Install and glue in the small rubber rod seal by slipping
it over the ON/OFF wire and gluing it in place.
Install the servos next. The front opening is for the throttle
servo and the rear for the steering servo. Install the servos
so the output shafts are towards the front of the radio box.
GrimRacer Says: The metal eyelets that
come with the servos are inserted from
the bottom side of the servo; this way the
rubber grommet is captured by the fl ange of the eyelet and
the built-in washer of the servo screw. This provides the best
vibration protection and strongest mounting for the servo.
Remove the servo arms from the servo and
clip the spokes as shown in the picture.