beautypg.com

Punch-in/out recording, Footswitch punch-in/out – Yamaha MT100II User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

PUNCH-IN/OUT RECORDING

Punch-'tn/out recording makes it possible to re-record a short segment of an otherwise perfect track in order to correct a mistake or

"brush up" an important passage. You "punch-in" at the point where you begin recording the new segment, and "punch-out" at the

end of the new segment so that the previously-recorded material is not erased.

Punch-in/out Using the REC SELECT Switches

1. With all REC SELECT switches set to OFF, start the re­

corder running — a few measures before the section to be

re-recorded begins — in the record-ready mode by press­

ing the REC button and then the PLAY button with aii track

REC SELECT switches set to OFF. The red REC LED will

flash indicating that the transport is in the record-ready

mode. The MONITOR SELECT switch should be set to

MONITOR so you can hear all the tracks.

2. At a convenient break in the track switch the track to be

corrected to the record mode (punch-in by switching the

REC SELECT switch for that track to the appropriate rec­

ord position) and start playing the new material to be re­

corded. The REC LED will light continuously as soon as

the REC SELECT switch is set to a record position.

3. At the end of the re-recorded segment switch the track

. back to the play mode (punch-out by switching the REC

SELECT switch for that track to OFF). The red REC LED

will begin to flash.

Footswitch Punch-in/out

1.

Plug a YAMAHA FS-1 (optional) footswitch into the

MT1 ООП PUNCH I/O jack.

2. Set the REC SELECT switch for the track to be punched-in

to the appropriate record position, and press the REC but­

ton to activate the rec/pause mode. The red REC LED

should flash instead of lighting continuously. If the red REC

LED lights continuously, press the footswitch once so that it

flashes. If the LED lights continuously, press the footswitch

once so that it flashes.

CAUTION:

WHEN USING A FOOTSWITCH, MAKE SURE

THE RED REC LED LIGHT IS FLASHING, NOT
STEADY BEFORE PUTTING THE TRANSPORT IN

RECORD. THIS WILL PREVENT ACCIDENTAL

ERASURE OF EXISTING MATERIAL. DO NOT

PRESS REC AND PLAY.

3. Press the PLAY button to start the transport running in the

record-ready mode.

4. Press the footswitch to punch-in. The red REC LED will

light continuously.

5. Press the footswitch a second time to punch-out. The red

REC LED will begin to flash.

TRACK 1

TRACK 2

TRACK 3

TRACK 4

All tracks monitored in PLAY­

BACK mode (the deck is in the
REC mode, but the track REC

SELECT switches are set to

OFF),

Begin playback

Ш

STOP

The record mode is engaged
for track 3 only when the track
3 REC SELECT switch is set
to an ON position.

It's a good idea to actually start playing a little
before the punch-in point.

21