Using the graphic equalizer – Yamaha MT100II User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING THE GRAPHIC EQUALIZER
The MT10011 has a stereo 5-band graphic equalizer built in. As the block diagram below makes clear, signals assigned to the left
and right channels by the PAN control and level adjusted using the MASTER fader are sent to the equalizer. Therefore, it can be
used during ping-pong recording, mixdown operation and when recording with the REC SELECT control set to "L" or "R." The
equalizer cannot be used when the REC SELECT control is set to "1" — “4, ” however, since each channel signal is recorded directly
on the appropriate track.
The graphic equalizer affects only the signal paths marked with bold lines in the diagram below.
(MONO)
AUX
RETURN
MIC/LINE
tNPUT
SELECT
>
TRACK
1,3
TRACK
2,4
n/
"7
AUX
RETURN
INPUT
FADER
PAN
REC
SELECT
MASTER
FADER
/
GRAPHIC
EQUALIZER
!/
GRAPHIC
EQUALIZER
REC
SELECT
/
AUX SEND
MONITOR
MONITOR
1,3
SELECT
MONITOR
MONITOR
2,4
SELECT
MONITOR /
PHONES
D/
/
MONITOR/
PHONES
STEREO OUT
AUXSEND
TAPE OUT
MONITOR OUT
PHONES
MONITOR OUT
18
MTIOOII MULTITRACK CASSETTE RECORDER