Craftsman 247.88110 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 12. LOCKOUT BRACKET ASSEMBLY
d.
Place the lockout bracket assembly under the
"T" portion of the upper handle with the bolt
ends facing up. See figure 12.
e. Place the clamp bracket over the bolt ends in the
lockout bracket assembly and secure with three
(3) Hex Center Lock Nuts Vi-20 Thd. See figure
12. Tighten nuts tight.
Step 4.
a. Start the two (2) self tapping screws 8-32 x ’/
2
"
in by hand which hold the throttle control to the
handle panel. See figure 13.
Throttle Control
(2) Self Tapping
Screws 8-32 x
Handle Panel
b.
Secure two (2) Self Tapping Screws 8-32 x ’/
2
"
holding throttle control to handle with a screw
driver tightly. See figure 13.
Step 5.
a. Place the handle panel with throttle control at
tached in position on handle assembly. See fig
ure 14.
Handle Panel
Si
Hex Center Lock Nut
'
4-20
Thd.
Hex Hd. Bolt
V
4
-
2
OX
Vy
Lg.
Handle Assembly
FIGURE 14. HANDLE PANEL ASSEMBLY TO HANDLE
FIGURE 13. THROTTLE ASSEMBLY TO PANEL