Craftsman 247.88110 - Manual (Page 14)

2. Remove the hex lock nut holding the lockout lever
in position.
3. Turn the lockout rod and lever in or out of the fer­
rule until the lockout lever lines up with the lock­
out bracket.
4. Secure lockout lever in position with hex lock nut.
CAUTION
Stop the engine and disconnect the
spark plug wire from the spark plug
before making any adjustments.
1. Cutting height adjustment is made by removing
and moving axle bolts to the desired positions. All
axle bolts must be mounted in the same relative
position to the deck. When wheels are mounted to
the deck, the crown shape washers must be assem­
bled with the crown away from the deck. This is
necessary to prevent the axle bolts from loosening.
Refer to figures 31, 32 and 33.
FIGURE 32. REAR WHEEL HEIGHT ADJUSTMENT
Front Wheel
FIGURE 31. FRONT WHEEL HEIGHT ADJUSTMENT
2. Upon reassembling the rear wheel, be sure the
crown washer is positioned in the inner frame
bracket. See figure 32.
Rear Wheel
Axle Bolt
FIGURE 33. CROWN WASHER LOCATION FOR REAR
WHEEL
CAUTION
Stop the engine and disconnect the
spark plug wire from the spark plug
before making any adjustments.
14