Hale AutoFill-E Tank Refill Control System - Manual (Page 21)

21 AUTOFIll-E Installer / User Guide
p/n: 029-0020-81-0
Routine Maintenance
❑
6 Routine Maintenance
WARNING!
BEFORE BEGINNING ANY INSPECTION OR MAINTENANCE OF THIS EQUIP-
MENT, VERIFY THAT THE PRESSURE HAS BEEN RELEASED FROM THE
SYSTEM.
LOCK OUT THE EQUIPMENT IN ACCORDANCE WITH THE MANUFAC-
TURER’S RECOMMENDATIONS AND YOUR DEPARTMENTAL REGULA-
TIONS / PROCEDURES.
OPEN THE DISCHARGE VALVES AND REMOVE THE SUCTION TUBE CAPS
AND DISCHARGE VALVE CAPS TO RELEASE ANY RESIDUAL PRESSURE.
The unique design of the Hale AutoFill-E Control System makes it virtually
maintenance free. However, as with any electromechanical system, peri-
odic inspection and lubrication is required to ensure a long, trouble-free life
(minimal downtime). See heading 6.1 “Procedures” on page 21.
6.1 PROCEDURES
The SVS Valve Assembly requires periodic maintenance, which is
explained in detail in the Installation, Maintenance and Operation Manual
provided with the unit (Hale p/n: 029-0020-
90-0).
Review this manual for all maintenance, troubleshooting or repair that may
be required to the SVS Valve.
The Intelli-Tank 4-Light Level Gauge and the Driver Module each have their
own manuals (see below). Refer to the following for maintenance and trou-
bleshooting procedures.
Intelli-Tank Manual....................... p/n: 106759 (021502)
Driver Module Manual ............... p/n: 106759 (12-15-03)
AutoFill Control System ................... p/n: 546-2730-00-0
(No maintenance required)