Hale AutoFill-E Tank Refill Control System - Manual (Page 15)

15 AUTOFIll-E Installer / User Guide
p/n: 029-0020-81-0
Installer Installation and Calibration
❑
Before mounting the display and adhering the label, insure that the unit is
positioned correctly (TOP is up). Refer to separate manual “Intelli-Tank
Water/Foam Tank Level Display,” p/n: 106759 (021502), located at the back
of this manual and packaged with the unit. Before installation and opera-
tion, review this manual in its entirety.
Relay Assembly and Power Distribution/Lighting Module
Both units must be mounted within proximity of the apparatus main pump
panel. The hole mounting pattern of each unit enables piggyback mounting,
using the appropriate standoffs, if necessary.
Refer to separate manual “Intelli-Tank High Current 4-Light Remote Driver
Module,” p/n: 106759 (12-15-03), located at the back of this manual and
packaged with the unit. Before installation and operation, review this man-
ual in its entirety.
Wire Harness
Standard industry-type harnesses are provided for:
❑ Power Distribution/Lighting Module, 8’ (2.4 meters) length,
p/n: 513-0550-00-0
❑ 12VDC Power Source, 18” (0.5 meters) length,
p/n: 513-0270-04-0, two (2) Units
❑ Water Level LED Gauge, 10’ (3 meters) length,
p/n: 513-0560-00-0
❑ Relay Electrical Valve Control, approximate 30” (0.8 meters) length,
p/n: 107777
❑ Electrical Valve Extension, 8’ (2.4 meters) length,
p/n: 107776
❑ AutoFill Extensions, 8’ (2.4 meters) length,
p/n: 513-0570-00-0
Note: When connecting the Manual Select Control Panel (p/n: 107720), make
certain the connectors are matched to the appropriate relay assembly and valve
connectors. See Plate #:1024AA located at the back of this manual.
If additional harness extensions are required, contact Hale Products at
610-825-6300.