Konica Minolta bizhub 552 - Manual (Page 227)

bizhub 652/552 10-22
10.4 Administrator Settings (G3) 10
Memory RX Setting
Specify whether to use Memory RX Setting function. To use the function, specify a password for print.
Press [No] to clear the entered setting and then specify a password using the keypad. (up to 8 digits)
The following screen is displayed if two units of the Fax Kit FK-502 are installed, and [Individual Receiving
Line Setup] is set to [ON] in Administrator Settings.
Press [Yes] and then specify a password using the keypad. (up to 8 digits)
The following items are not available if Memory RX Settings are configured.
- PC-Fax RX Settings
- TSI User Box Settings
- Forward TX Setting
Reference
- For details on printing documents stored in a Memory RX User Box, refer to the [User's Guide Box Op-
erations]
- You can also specify the registered group as the destination.
Item Description
[Confirm Address (TX)]
(G3) When specifying a fax destination with direct input, a screen appears
prompting you to enter the fax number again for confirmation. Entering the
fax number twice prevents one from entering incorrect destinations.
•
When Confirm Address (TX) is enabled, you cannot specify a destination
using [Off-Hook]. You cannot specify the fax address using [Job History]
either.
[Confirm Address (Regis-
ter)] (G3) When the user specify a fax destination when the user registers a program,
configures the fax forwarding settings, or registers a one-touch destination,
the user must enter the destination twice for confirmation. By entering twice,
you can prevent the destination from being incorrectly entered.