Kramer Electronics PL-50 User Manual
Page 32
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your PL-50 Power Controller – Monitor
28
To set the Standby mode
1. Press one or more OUT buttons to select the channels for which you want to
measure the standby or active modes.
The selected buttons illuminate.
, do the following:
2. Set the connected units to the Standby mode
3. Press the PRESET LEVEL STANDBY button.
The selected orange OUT buttons, and their related STANDBY orange LEDs
blink.
4. Press each of the selected orange blinking buttons to initialize the
measurement.
The STANDBY orange LED blinks until measurement is complete.
To reset the active and standby values on all channels, press the RESET
button on the rear panel while turning the power ON.
You can measure the Active and Standby values as well as reset individual
channels via the embedded Web pages (see section
1 The unit should be powered up and running under typical conditions when the measurements are made