Kramer Electronics PL-50 - Manual (Page 12)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the PL-50 Power Controller - Monitor
8
6 Connecting the PL-50 Power Controller - Monitor
To connect the PL-50, as illustrated in the example in Figure 4 , do the following 1
1. Connect up to five
:
2
 OUT 1 to a DVD player
outlets (from 1 to 5). For example, connect:
 OUT 2 to an LCD display
 OUT 4 to a power amplifier with speakers
 OUT 5 to a lighting system
2. Set the DIP-switches (see Table 2 ).
3. Connect an item (for example, an alarm) via the RELAY and/or DIGITAL
CONTROL terminal block connectors (not shown in Figure 4 ).
4. As an option you can connect a PC and/or controller to the RS-232 port,
RS-485 port and/or the ETHERNET connector (see section 6.2.1 )
5. Connect the power cord 3 Figure 4 (not shown in ).
Figure 4: Connecting the PL-50
1 Be sure that the power is switched OFF on each device before connecting it to your PL-50. After connecting all the devices
to your PL-50, switch on the power of the PL-50, and then switch on the power of each device
2 You do not have to connect all the outlets. In this example OUT 3 is not connected
3 We recommend that you use only the power cord that is supplied with this machine