Kramer Electronics PL-50 - Manual (Page 23)

Connecting the PL-50 Power Controller - Monitor
19
6.3.5 The Alerts Screen
Figure 19 and Table 6 define the Alerts screen:
Figure 19: The Alerts Screen
Table 6: The Alerts Screen Features
Feature Function
Alert Triggers: Select the event that will trigger an alarm:
Check the Enable box to enable the event and action taken or clear to disable
The events:
TO OFF – the outlet turns OFF (the channel button is off)
TO ON – the outlet turns ON (the channel button is on)
TO ACTIVE – the green LED is ON
TO STANDBY – the orange LED is ON
TO NONE – the outlet is disconnected
ANY CHANGE – any change in the current status
Read: click to read the data stored in the machine
Submit: click to submit changes
Alarm
configuration:
Relay Starts As: set the relay status to closed or open according to the relay
installation. For example, if the alarm is installed so that in the closed state the
alarm is off set it to Closed
Duration: set the duration of the alarm in seconds
Test Alarm: click this button to test the alarm, click again to silence it
An alarm icon appears on the top right side of the screen. Stop the alarm by
clicking the Alarm icon (see Figure 20 )
Read: click to read the data stored in the machine
Submit: click to submit changes