In-Situ Tube 300R Telemetry System - Manual (Page 25)

800-446-7488 25 www.in-situ.com
6
Enables/disables the Tube to power the connected probe. Must be enabled when
an Aqua TROLL 400 or RDO PRO probe is connected. Do not enable for other
instruments when using the Tube 300R models.
7
Enables/disables an initial probe warmup period prior to requesting data. This
option should be enabled.
8
Designates the duration of the probe warmup period in seconds. In-Situ
recommends 1 second.
9
Enables/disables a general test when the Tube is first started. A general test takes
probe readings and sends the data via email or FTP. The Tube is in "Started"
mode by default when power connected.
10 Designates the time delay before the Tube performs the general test in minutes.
11 Enables/disables the Tube from attempting to resend data when it fails to transmit.
12
Enables/disables the Tube to send data without file header information. This option
should remain disabled.
13 Enables/disables the modem sleep function. This option should remain disabled.
14 Selects whether the Tube sends data via email or FTP.
15
Enables/disables use of custom decimal separators. The default separator is a
period.
16 Writes settings to the Tube.