In-Situ Tube 300R Telemetry System - Manual (Page 12)

800-446-7488 12 www.in-situ.com
Set the Site Name and Clock
1. Click General information, parameters and functional options.
2. Click the Information tab.
3. Enter a Site name for your deployment area and click Set the Site Name.
4. Click Set clock to synchronize the Tube clock with your computer clock.
5. Close the window.
Configure Options
1. Click General information, parameters and functional options.
2. Click the Options tab.
3. "Barometric compensation for level readings" is only changeable if you have a Tube
with an internal barometric sensor. Enter a manual value for the density of water if
needed.
4. Select "Power supply to the probes" if you are deploying an Aqua TROLL 400 or
RDO PRO-X probe.
5. Select "Warmup time for the probes." Set the Probe warmup time to 1.
6. Select "Retry data sending in case of error."
7. Select whether to send data to an email address or to an FTP site.
8. Click the Write options button.
9. Close the window.
Modem Parameters
1. Click the Modem parameters tab.
2. Enter the Access point name (APN) in the field under "GPRS connection". If you
purchased a SIM card and data plan through In-Situ Inc., your access point name is:
m2m.com.attz
If you are using a third-party cellular service provider, you must
contact them for your APN.
3. If your cellular service provider requires a user name and password, enter those in
the fields under the access point name. In-Situ Inc. does not require a user name or
password.