Hawk Industries Spinner Manual 550 HYDRAULIC Serial Numbers 1 to 205 - Manual (Page 33)

33 Maintenance & Repair
Air Power Pack Maintenance
BODY ASSEMBLY
SEAL HOLDER
DEFLECTOR / SHROUD
GASKET (ELEMENT)
HOLDER (ELEMENT)
BOWL ASSEMBLY
AUTO DRAIN
( Looks different than shown)
BAFFLE
GASKET (ELEMENT)
SEAL (BODY TO BOWL)
ELEMENT (FILTER)
1. The air filter element should be
changed once every three (3)
months.
2. Unscrew the air filter bowl
(AFB) and replace the element.
3. The filter is an auto-drain type.
Make sure the auto-drain
system is working correctly by
checking the fluid level sight
gage (FSG) on the side of the
bowl. If the fluid level is higher
than the middle of the sight
gage, the auto-drain is mal-
functioning. Replace the auto-
drain as shown in the filter
diagram below.
Changing Air Filter Element
FSG
002-F17 Air Filter
Air Filter Maintenance
ELEMENT 002-F17-1
ITEM P/N
DRAIN 002-F17-2
NOTE
Clean and dry air is essential for
maximum Spinmaster performance
and dependability.
AFB