Hawk Industries Spinner Manual 550 HYDRAULIC Serial Numbers 1 to 205 - Manual (Page 19)

19
Lubricant Required
1. Use the 7/16" wrench to remove
the rubber Safety shield bolts
(B).
2. Remove rubber Safety shield
(S).
3. While spinning out of the hole,
from the back of the spinner,
apply Pinion Grease Spray
(PGS) to all links of the chain.
4. Replace rubber Safety shield
(S).
5. Use the 7/16" wrench to replace
the rubber Safety shield bolts
(B).
Grease Once per Week
Chain
S
WARNING
Keep hands away from the main
drive sprocket while spraying the
chain.
B
PGS
Chevron Pinion Grease Spray
(Part # MS-SP), 7/16" wrench
WARNING
Run spinner only when gripped on
a pipe body.
NOTE
Never under any conditions apply
weight materials or any other dry
materials to the chain.
Lubrication
Maintenance & Repair