Hawk Industries Spinner Manual 550 HYDRAULIC Serial Numbers 1 to 205 - Manual (Page 10)

10
Installation
SC SH
SH
S
1. Connect the Spring Hanger
(SH) to at least a 3/8"diameter
Steel Cable (SC) suspended
from a high point (as near the
crown as possible) in the derrick
no more than 5 ft. from the
center of the Rotary Table.
2. Connect the lower end of the
spring hanger (SH) to the
Spinmaster as shown. Make
sure the shackles (S) are tight-
ened securely. Make sure that
the Spinmaster hangs in the
derrick at a level that assures no
contact with any part of the
stabbed tool joint (including the
upset) when gripped on tube.
3. Hook a backup line to the rear
of the Spinmaster securing the
other end to the derrick. Make
sure the backup line is horizon-
tal and leaves little slack when
the Spinmaster is gripped on the
pipe so that no kick-back can
occur when changing spinner
motor directions.
Suspension
Caution
Hooking up the back-up line on an
angle not level with the spinner can
cause damage to the spinner case.
Part Name Part #
Spring Hanger Assy. (SH) 002-50274
Part Numbers
Warning
Failure to properly hook up back-
up line could cause bodily injury.
Installation