Start-up procedure – Hawk Industries Hawkjaw Sr. Manual M100K-2GSR Serial Numbers 201 to 370 User Manual

Page 19

1. Connect the air power source with

the Air (A) line.

2. Make sure the hydraulic reservoir is

full.

3. Connect the hydraulic Pressure (P)

and Tank (T) lines. The Pressure
line (P) Quick Disconnect is male.

4. Make sure the “E” stop (E) is pulled

out.

5. Check for hydraulic leaks. If leaks

occur, see Trouble Shooting.

6. With the exception of the hooks

retracting, no motion should occur.

If any other parts on the HawkJaw

move, see Trouble Shooting.

NOTE

Tightly connect the quick disconnects.

A loose connection causes a pressure drop

in the hydraulic fluid which heats up the

fluid and reduces component life.

NOTE

Use only Hawk approved quick

disconnects.

Part Numbers

Part Name

Part #

Male Quick Disconnect (P) 061-H52

Female Quick Disconnect (T) 061-H53

Male Air Quick Disc. (A) 061-A12M

Female Air Quick Disc. 061-A12F

Start-Up Procedure

T P

Operation 17