Hawk Industries Hawkjaw Sr. Manual M100K-2GSR Serial Numbers 201 to 370 - Manual (Page 13)

1. Pressure compensated pump set to
pressure compensate at 2500 psi.
2. Minimum volume of 20 gpm. 35 gpm for
top performance.
3. 1" minimum Pressure line. 1 1/4"
Pressure line if the power unit is located
more than 100' apart from the HawkJaw.
The hose working pressure must be 3000
psi or greater.
4. 1 1/4" minimum Tank line. 500 psi
minimum hose working pressure.
5. Hawk approved quick disconnects [Male:
Part # 061-H52 (MQD). Female: Part
# 061-H53 (FQD)]. Initial quick disconnects
supplied with the HawkJaw.
6. Hydraulic power unit located in a clean,
dry, ventilated area.
7. Enough slack in the lines for the HawkJaw
to move from its rest position to the drill
pipe connection to the mousehole
connection.
WARNING
The HawkJaw is a closed center system which must
have a pressure compensated volume controlled
power unit. If the only available hydraulic power
unit is constant volume, then the optional hydrau-
lic converter kit (Part # 061-J80) is required. Run-
ning the HawkJaw with a constant volume hydraulic
power unit may result in bodily injury and will cause
damage to the HawkJaw and to the hydraulic
power unit.
WARNING
The HawkJaw must receive clean hydraulic fluid.
Running the HawkJaw without a Hawk approved
filter (Part # 061-H25) and installed filter element
(Part # 061-H25A) voids the warranty and severely
shortens component life.
Installation 11
FQD Tank MQD Pressure
Hydraulic Requirements Hydraulic Requirements