6 the water gets too hot and stops the machine – Power Soak 34774 PS-225 Service Manual User Manual
Page 45
39
Solution
1. Clean the face of the sensor with a washcloth and soapy water.
2. Check the nut that secures the wire to the sensor on the outside of the tank.
9.6 The water gets too hot and stops the machine.
Possible Cause
The Triac has failed and is passing current to the heater when it is turned off.
Solution
With the machine operating, check the amperage on the heating element wires when
the indicator light goes off. If the current does not go off when the indicator light is off,
the Triac is defective.
9.7 The chemical dispenser pump runs, but does not pump the
chemical.
Possible Cause
The hose has been punctured or ruptured.
Solution
Replace the defective hose with a new hose.
If the trouble shooting procedures do not correct the problem, contact Power Soak
Systems, Inc. at 800-444-9624 or an authorized service agency.