Adaptec AHA-1510A User Manual

Page 5

iii

AHA-1510A/20A Series User’s Guide
Stock Number: 510400-00, Rev. C

Page: iii

Print Spec Number: 491842-00
Current Date: 11/18/94

ECN Date: 11/29/94

AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA

AAAA

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in residential installations. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.

If this equipment does cause interference to radio or television equipment reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Move the equipment away from the receiver

• Plug the equipment into an outlet on a circuit different from that to which the receiver is

powered

• If necessary, the user should consult the dealer or an experienced radio/television technician

for additional suggestions

CAUTION: Only equipment certified to comply with Class B (computer input/output devices,
terminals, printers, etc.) should be attached to this equipment, and must have shielded interface
cables.

Finally, any changes or modifications to the equipment by the user not expressly approved by the
grantee or manufacturer could void the user ’s authority to operate such equipment.

Each host adapter is equipped with an FCC compliance label which shows only the FCC identifi-
cation number. The full text of the associated label follows:

This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

This manual is related to the following products:

AHA-1520A