FEC AFC1500 - Manual (Page 86)

Chapter 5: Power Up and Initial Checks
Page 5-4
4. Verify operation of manual start.
P Press the START button on the Main unit and verify that all tools run in the correct direction until
the pre-programmed time elapses, creating a reject.
P Press the RESET button on the Main operator panel to clear the REJECT light and LED outputs
from the San Units.
5. Verify System operation by external commands.
P Confirm that the equipment operates correctly when PLC inputs and outputs are activated. Use the
PLC to perform all of the functions (START, CAL, etc.) that were manually activated earlier in this
Section.