FEC AFC1500 - Manual (Page 138)

Chapter 7: System Operations
Page 7-24
7.3.2 Setup Mode selection
Depressing the Mode button will initiate the Setup mode.
Immediately after the setup mode is established, a blinking number will appear in the [PARM]
display. The cursor (blinking mode) will move each time the [MODE] button is pressed to the
next character to the right.
The blinking character can be increased or decreased using the [
 ] and [  ] buttons . The [D-
NO] characters will display the data corresponding to the Parameter data list (7.2.5). The
[DATA] characters will display the actual value of the [D-NO] as it is currently set. You may
edit the currently indicated data using the Data Edit mode. Press the [SET] button to enter in-
to the Data Edit mode on the indicated D-NO. you want to change. (see 7.3.3 for detail)
FIG. 7-3-2 Setup mode D-No selection