FEC AFC1500 - Manual (Page 38)

Chapter 3: System Description
Page 3-8
3.3 AFC1500 Keyboard-Display unit - SAN DP1/DP3 – SAN3-DP1
The SAN(3)-DP1 display unit is a “hot-swappable” detachable display also incorporating program-
ming and monitor functions as well into this optional unit. It attaches directly to the front of the SAN
unit through connector CON1 and can be removed or attached with power on. It is not required for
the system to operate. Programming of parameters can be accomplished using the programming
keys. For multiple spindle applications the AFC User Console Programming software is more efficient
method of programming.
NOTE: Refer to Chapter 7 for detailed operation using the SAN(3)-DP units.
FIG. 3-3 SAN - DP1 Keyboard -Display unit
ITEM AS MARKED ON UNIT DESCRIPTION
START Manual fastening start pushbutton.
REV Manual reverse pushbutton.
CAL Manual Calibration (CAL) Check pushbutton
RESET Manual Zero Check and System reset pushbutton.
DATA Four digit display where function is dependent upon the D-NO selected.
PARM
Displays two-digit parameter number and, as required, will override Pa-
rameter output to display an Abnormal code.
D-NO
Display number that indicates which data in the "DATA" display field is
being displayed and as required, will display an Abnormal Sub-code.
UP Data change increase pushbutton.
DOWN Data change decrease pushbutton.
MODE Display mode selection pushbutton.
SET Data change confirmation set pushbutton.
D-NO PARM
SET
DATA
REV START CAL RESET
DATA
Mounting
flange on
DP3 and
DP4 only
The SAN display units come in (2) different widths
to allow mounting to the SAN Units
SAN-DP1 & DP2 can be used on the following SAN
Units:
• SAN2-12, SAN2-40,
SAN3-24(H), SAN3-40, SAN3-60H
SAN-DP3 & DP4 can be used on the following SAN
Units;
• SAN2-80, SAN2-120,
SAN3-120T, SAN3-120W
(These units have a wider mounting flange)
SAN3-DP1 & DP2 units were introduced in 2009
and are RoHs compatible replacements of the 1
st
generation SAN-DP units. These units also include
the addition of a real time clock (RTC) function for
stand-alone systems. (see 7.2.5 Parameter Data
List for clock setup)
SAN3-DP1 & SAN3-DP2 can now be used on ALL
SAN units. (DP2 has a serial port)