KT&C KVR-0412H - Manual (Page 197)

197
12.5.2 Port Setting
 Press ( ) the “Port Setting” button in order to set up the port. Default values are Baud rate 2400 bps, Data Bit 5 bit, Stop Bit
1 bit, Parity None.
 When the setup is done, press enter ( ) to save the setting.
12.5.3 OSD Display
 OSD items are to decide whether to display the information from the serial port connected to the rs232 port on OSD screen.
 They have 4 menus as followings:
- None: displays nothing on the OSD screen.
- Live: displays incoming information from the serial port in real time on the OSD screen.
- Playback: displays the saved information on the OSD screen during replay.
- Both: displays all the information on both Live and Playback mode.
12.5.4 Pattern Setting
 User can select the name of serial device if click ( ) the keyboard button of Title.
 When “Use” items of Numbers 1-4 are checked on Serial-In page, it receives the data from the applicable serial device.
 Check the “Auto” item so as to capture automatically all the data which includes unnecessary dummy data out of serial
device as below.
 Analyze among the automatically captured data which will be displayed or discarded then enter Pattern Setting.
- Unless user checks “Auto” item, make sure to set up “Start Pattern” and “End Pattern”
- “Discard Pattern”, “Line Delimiter” and “MCPL” are utilized independently, not relation to “Auto” mode.
 It is possible to input and analyze the serial data by clicking “Pattern” after tick the “Auto” box(□) off.