GxT V095-01 Automotive Analyzer - Manual (Page 11)

11
Volts • Amps
Pressing the button will
cycle you through the
Volts•Amps Display and a
Battery/Starter Test. The
High range amp probe is used during
this test. The Volts•Amps function
displays Amps on the top display, and
battery voltage on the bottom display.
The Battery/Starter Test will display a Crank Engine message
(CrnEng). To set up the test, connect the test leads to the vehicle
battery terminals, and place the Amp Probe onto the negative
battery cable, and disable the ignition. To start the test, crank
the engine. After 15 seconds of cranking the freeze readings will
freeze
Supported Functions:
V•A
HOLD Range
Volts Amps Display
38 2
88 0 1
LOBAT
MAX
MIN
AMPS
V
HOLD