GxT V095-01 Automotive Analyzer - Manual (Page 10)

10
Lo Amps
When the test is first
selected the message
“PLUG In LO” will be
briefly displayed to remind
the user that the Low range Amps
probe should be plugged into the
Amps socket. Pressing the button will
cycle you through DC Lo Amps, AC Lo
Amps, and AC Peak to Peak Lo Amps.
The bargraph is a easy way to see
trends in low amps being measured.
The DC Lo Amps function can measure
from 10 milliamps to 20 Amps. The AC
functions use a certified true RMS chip
to provide accurate interpretations
of AC waveforms. The Peak to Peak
function is the best measurement
tool to determine the amplitude of the
signal.
Note: AC auto ranging takes more time to occur than DC auto
ranging. This is to allow the AC peak and rms circuits to settle
after the abrupt change in scaling.
Supported Functions:
Lo A
50 2 1
72 9 1
LOBAT
MAX
MIN
RPM
2C
-
AUTO
m A
HOLD
REL 0
DC LoAmps Display
00 5 2
88 8 1
LOBAT
MAX
MIN
RPM
4C
AC
AUTO
m A
HOLD
REL 0
AC LoAmps Display
2C/4C HOLD
Min
Max Range
REL
Zero