beautypg.com

Cranking analysis” key, Step one basic test, Test variations – GxT Ferret 63 DIAGNOSTIC ENGINE ANALYZER User Manual

Page 22: Start, Warning, Switch accessories off! close doors, then start

background image

“CRANKING ANALYSIS” KEY

CRANKING HISTORY

An electrical power system test of the

engine is the primary feature of this se-

quenced procedure. Performance mea-

surements of the alternator, battery, and

starter allow comparison to ratings.

This test records battery voltage and amps while the

starter cranks the engine for 15 seconds, then there

is a wait to check battery recovery time, followed by a

measurement of the charging current when the engine

is started.

The Cranking Analysis test procedure for a standard

engine follows the basic test procedure in the left-hand

column below. Test variations are described in the right-

hand column for nonstandard vehicles and conditions.

SENSOR

TEST

02

TPS

SETUP

AMP ZERO

SELECT

MESSAGE

PRINT

DISPLAY

PRINT

AUTOTEST

CHARGING

STARTING

AMPS

VOLTS

IGNITION

PRIMARY

COIL

MODULE

DWELL VARIATION

AUXILIARY

AUXILIARY

PER CYLINDER

CRANKING

ANALYSIS

COMPRESSION

BAT. STARTER ALT.

POWER

BALANCE

% RPM DROP

AUTO

MANUAL

PER CYLINDER

SPARK

BURN

SECONDARY

MSEC

SLOPE

PER CYLINDER

HARD

START

IGNITION

VOLTS

AUXILIARY

FUEL

INJECTION

MSEC, % DUTY, HZ

AUXILIARY

START

PAPER

ADVANCE

STEP ONE

BASIC TEST

You should have completed the analyzer SETUP steps,

including the check for good readings with HARD

START.

Press CRANKING ANALYSIS” to begin.

Press START.

Using SELECT, there is a choice of the complete

“Cranking History” test or doing the “Electronic Compres-

sion” test.

SELECT “Cranking History”, press START.

Keep the car doors closed during the test to reduce bat-

tery drain.

Press START.

TEST VARIATIONS

If the test has been done before, it will show:

Running a new test will erase the old data when the new

data recording begins.

The test will stop if the battery is below 12.30V indicating

a discharged, weak, or loaded battery.

CRANKING ANALYSIS
Engine Warm, Brakes Set.

SELECT: run NEW TEST
START : view OLD DATA

DISCHARGE

15 SECONDS

RECOVERY

TIME

CHARGING

MEASUREMENT

CRANKING

VOLTS

CHARGING

AMPS

14V

12V

10V

OPERATOR

ACTIVITY

CHARGE

DISCHARGE

VOLTS

WAIT

FOR

BATTERY

RUN

ENGINE

CRANK

ENGINE

CRANKING AMPS

CRANKING HISTORY TEST

-20-

Switch ACCESSORIES OFF!
Close Doors, then START

WARNING

THE ENGINE MAY START DURING THE TEST.

SELECT: Compression
TEST then START

Bat 12.04
Recharge BATTERY