IPX DDK-1700 User Manual
Page 37
Changing the PPPoE Network Settings.
Follow the steps below to change the PPPoE settings.
1. Click
the
PPPoE
button on the upper left menu to enter the “PPPoE Settings” page.
2.
Activate the “Enable” or “Disable” status of the PPPoE Settings.
3.
Enter the PPPoE “Username” and the PPPoE “Password” and then confirm the password again.
4.
Click on the Submit button to save the settings.
NOTE: Please refer to section 4.1.3.8 (PPPoE & DDNS) for more details.
Functions:
PPPoE Setting
If you use the DDK-1700 to connect directly to the Internet, you will need to
enter the username and password which were given to you when you set
up your account with your Internet Service Provider. If the DDK-1700 is
behind a router or a gateway you do not need to configure this setting.
Username:
Enter Username here
Password:
Enter Password here
37