Ohaus CD-33 Indicator - Manual (Page 41)

41
CD Indicators
Command Command Command Command Command
Character Character Character Character Character Description Description Description Description Description
? ? ? ? ? Print current mode: g, kg, custm, %, #
nnnA nnnA nnnA nnnA nnnA Set Auto Print feature to "nnnn".
nnnn=0 Turns feature OFF
nnnn=S Output on stability
nnnn=C Output is continuous
nnnn=1-3600 Sets Auto Print interval
C C C C C Begin span calibration.
F F F F F Print current function.
xl xl xl xl xl Set Averaging Filter to "x", where x = 0 to 3.
If LFT, level 0 to 1.
0=minimum level
1=
2=
3= maximum level
L L L L L Begin linearity calibration.
xM xM xM xM xM Places terminal in mode "x", where x = 1 to 4.
If unit is not already enabled, command returns ES.
1=grams
2=kilograms
3= pounds
4= custom units
P P P P P Print display data.
xSL xSL xSL xSL xSL Set stable data only printing TO "X", where x = 0 to 3.
If LFT, x=0 or 1.
0=.5d
1= 1d
2= 2d
3=5d
T T T T T Same effect as pressing Tare Key.
N N N N N Shows copyright notice.
V V V V V Print software version number.
EscV EscV EscV EscV EscV Print scale ID
xZ xZ xZ xZ xZ Set Auto Zero to "x", where x=0 to 3.
If LFT, Auto Zero level from 0 to 1.
0=off
1=0.5d
2=1d
3=3d
x% x% x% x% x% Set % reference weight. Uses real number "x" as current Percent Reference Weight.
Weight must be entered in Calibration Units.
x# x# x# x# x# Set PC reference weight. Uses real number "x" as current Parts reference Weight. Weight
must be entered in Calibration Units.
EscR EscR EscR EscR EscR Resets setup and print menus to factory defaults.
CAUTION: This will reset RS232 configuration.
# # # # # Print current Parts Count Reference Weight in the most recently used Units.
% % % % % Print current Percent Reference Weight in the most recently used Units.
xF xF xF xF xF Set current function to "x", where x=0 to 4.
If mode is not already enabled, command returns ES.
0=None (normal weigh)
RS232 COMMAND TABLE
4.7 Printing Data (Cont.)
4.7.2 Output Formats (Cont.)