Acumen AiP-Q4U User Manual

Page 48

AiP-N series 16CH/9CH/4CH Manual

1.4-2 Alarm input type

The NVR's alarm inputs can be configured as normally open (N/O) or normally closed (N/C) for

AiP cameras where the alarm signal from an AiP camera activates an alarm.

1.4-3 Motion enable
‘Motion Enable’ enables motion alarm recording, after the motion detection area (‘Motion Area Setup’) has

been set. Press Left or Right at Motion Enable to change the setting.

1.4-4 Motion sensitivity

There are eight levels of sensitivity adjustable for motion alarm triggering,

ranging from ‘Highest’ to ‘Lowest’.

Press Left or Right to change the sensitivity setting.

1.4-5 Motion area setup

There are a number of ways to set the motion detection area. The detailed setting sequence is described as

follows:

Keypad

Keyboard

Remote

controller

Mouse

Step 1

Enter Motion Area Set menu item.

Step 2

Press Up, Down, Left, or Right to move cursor

Move mouse for starting position

Step 3

Press Enter to define starting area

Step 4

Press Enter again to finish a motion detection zone

Mouse-drag for an area

Step 5

To clear motion zones press Menu button

Double-click for clear motion zones

Step 6

Press ESC for exit the setting menu

Move mouse to “X” icon and press
Left-mouse click to exit motion zone

setting

Red indicates motion area

1.4-6 Alarm time

Set the period of time 1-100 seconds the alarm output relay is triggered upon an alarm event