8e6 Technologies Enterprise Reporter SL-002-002 - Manual (Page 70)

66 8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide
66 8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide
a
ppendix
: san i
nstallation
G. Turn on the power switches at the back of the storage device,
which are positioned to the right of the power cord connectors.
The boot-up process may take up to 5 minutes. When the unit
is booted up, the three vertical LED lights at the left of the front
panel will be lit up (see Figure 3).
Once all LED lights are lit, the ER can be powered on.
Shut Down, Restart Procedures
Follow the procedures in this section if you need to shut down or
restart the storage device.
Shut Down the Storage Device Unit
If you need to shut down the storage device, always follow these
steps:
Figure 3: LED
display
A. Power off the ER unit first. (Refer to the Physically Connect the ER to the Network
sub-step in Step 1B of the ER section for shut down procedures.)
B. Power off the storage device next by turning off both switches in the back of the unit.
Restart the Storage Device Unit
The storage device must be restarted after a power failure. In this instance, the storage
device may already be turned on, but needs to be booted up again.
WARNING: You must always power on the storage device before powering on
the ER unit. Since the storage device is an information database, if you experience
a power interruption or if you power off the storage device without going through
the standard shut down procedures, you may lose data and/or damage the file
system.
To restart the storage device, press the power button on the front panel. The boot-up
process may take up to 5 minutes.