Yamaha PJP-100H - Manual (Page 47)

43
Updating the Firmware
CONF
IGUR
A
T
IO
NS
English
Follow the procedure below to install the latest firmware
automatically.
• Automatic firmware update can be performed only if this unit
can be connected to the internet. If not, follow the procedure in
“Updating the firmware manually” (page 44).
• Once the firmware update is started, do not perform any other
operation until update is completed and this unit is restarted. If
the update operation is interrupted, this unit may become
unusable, in which case this unit needs to be returned to the
factory to repair.
• When the firmware update is completed, this unit is restarted
automatically. All of the calls being connected are disconnected
at this time.
• Do not unplug the LAN cable during the firmware update.
Otherwise, this unit could become unusable and may need to be
returned to the factory to repair.
y
You can specify any URL to download the firmware (page 44).
1
Press in the initial display.
The menu display appears.
2
Press or to select “1. Settings”, and
then press .
The “Settings” menu appears.
3
Press , and then press or to select
“5. Firmware Update”.
4
Press .
The “Firmware Update” menu appears.
5
Press or to select “1. Yes”, and then
press .
This unit is connected to the internet and downloads
the latest firmware. When downloading is completed,
the firmware update is automatically started.
The firmware update process takes a few
minutes to complete.
MIC MUTE (red LED) on the top panel of this unit
flashes during the firmware update process. Do not turn
this unit off while MIC MUTE (red LED) flashes.
■ When the firmware update is complete
This unit restarts automatically.
Check the version number in the “Program Version” field
on the top of the web menu to confirm that the new
firmware is installed properly.
Updating the firmware automatically
Notes
1 2 3
4 5 6
7 8 9
0
MIC MUTE
LAN
VOL
DC IN 12V
IN AUDIO OUT
3. General Settings
2. Sound Settings
1. Network Settings
Settings
5. Firmware Update
4. Restore Settings
3. General Settings
Settings
2. No
1. Yes
ver. DT1.12-V1.6x
Firmware Update
01EN_00_PJP-100H_UCGB.book Page 43 Wednesday, August 23, 2006 3:04 PM