Yamaha PJP-100H - Manual (Page 45)

41
Hierarchical Connection of Multiple PJP Units (Cascade Connection)
CONF
IGUR
A
T
IO
NS
English
First configure the setting of cascade server unit, and then
configure the settings of the cascade client units.
■ Step 1. Configure the setting of the
cascade server.
1
Press in the initial display.
The menu screen appears.
2
Press or to select “1. Settings”, and
then press .
The “Settings” menu appears.
3
Press or to select “1. Network Settings”,
and then press .
The “Network Settings” menu appears.
4
Press or to select “6. Connection
Mode”, and then press .
The “Connection Mode” menu appears.
5
Press or to select “1. Cascade Server”,
and then press .
The settings are saved.
Return to the initial display and check that is
displayed at the top of the display.
■ Step 2. Configure the settings of the
cascade clients
Follow the procedure in “Step 1. Configure the setting of
the cascade server.” above and select “2. Cascade Client”
in step 5.
After completing the setting, return to the initial display
and check that
is displayed at the top of the display.
The IP addresses of this unit and other units connected to
this unit are displayed during call.
The mark displayed before each IP address indicates the
cascade connection mode of each unit.
• : The unit is set to “Cascade Server”.
• : The unit is set to “Cascade Client”.
Configuring the cascade settings Display in cascade connection
Menu :Address
192.168.0.10
192.168.100.20
192.168.100.30
IP address of this unit
IP address of other units
01EN_00_PJP-100H_UCGB.book Page 41 Wednesday, August 23, 2006 3:04 PM