Yamaha PJP-100H User Manual

Page 14

Preparation Procedure

Register the IP address and subnet mask of this unit, and the default gateway and DNS server used by it according to the
environment of the LAN in which this unit is accommodated. The operation is different depending on whether or not the
DHCP server is used.

Set a unique IP address to this unit so that it does not overlap with
the IP address of any other equipment already existing in the
LAN.

■ Obtaining the IP address automatically

When this unit is used in a network containing a DHCP
server, no setting operation is required since the DHCP
server assigns all of the necessary network information
automatically.

To check if the correct network information
is obtained

Confirm that the IP address of this unit is displayed in the
initial display as shown below.

If the IP address display is “???.???.???.???”

The network information is not obtained correctly.

If the disconnected icon is displayed, this unit is not
connected properly to the network.

– Check if the LAN cable is connected properly.
– Check the condition of the network to which the

LAN cable is connected.

If the icon is not displayed, the network information is
not obtained from the DHCP server.

– There may be a network fault between this unit and

the DHCP server. Consult your system
administrator to solve the trouble with the network.

– If the problem cannot be solved, register the

network information manually (page 11).

Step 2: Registering the network settings of this unit

Note

:Address

IP: 192.168.0.12

:Address

IP: ???.???.???.???

Disconnected icon

01EN_00_PJP-100H_UCGB.book Page 10 Wednesday, August 23, 2006 3:04 PM