Novatel GNSS Receiver and Antenna SMART-AG - Manual (Page 67)

SMART-AG User Manual Rev 5 67
Table 10: COM Serial Port Identifiers
Table 11: Parity
 Watch for situations where the COM ports of two receivers are connected
together and the baud rates do not match. Data transmitted through a port
operating at a slower baud rate may be misinterpreted as break signals by the
receiving port if it is operating at a higher baud rate.
This is because data transmitted at the lower baud rate is stretched relative to the
higher baud rate. In this case, configure the receiving port to have break
detection disabled using the COM command.
Binary ASCII Description
1 COM1 COM port 1
2 COM2 COM port 2
3 COM3 COM port 3
6 THISPORT The current COM port
8 ALL All COM ports
9
XCOM1
a
a. The XCOM1, XCOM2 and XCOM3 identifiers are not
available with the COM command but may be used with
other commands.
Virtual COM1 port
10
XCOM2
a Virtual COM2 port
13
USB1 b
b. USB is not available on the SMART-AG.
USB port 1
14
USB2
b USB port 2
15
USB3 b USB port 3
16 AUX AUX port
17
XCOM3 a Virtual COM3 port
Binary ASCII Description
0 N No parity (default)
1 E Even parity
2 O Odd parity