Open file in winload, Com port setup, Searching for card – Novatel GNSS Receiver and Antenna SMART-AG User Manual
Page 51
PC Utilities
Chapter 4
SMART-AG User Manual Rev 5
51
Once you have selected your file, the name should appear in the main display area and in the title bar,
see Figure 15 below.
Figure 15: Open File in WinLoad
Communications Settings
To set the communications port and baud rate, select COM Settings from the Settings menu. Choose
the port on your PC from the Com Port dropdown list and the baud rate from the Download Baudrate
dropdown list. The baud rate should be as high as possible (the default of 115200 is preferred).
Figure 16: COM Port Setup
Downloading firmware
To download firmware follow these steps:
1. Set up the communications port as described in Communications Settings above.
2. Select the file to download, see Open a File to Download on Page 50.
3. Make sure the file path and file name are displayed in main display area, see Figure 15, Open File
4. Click on the Write Flash button to download the firmware.
5. Power down and then power up the receiver when “Searching for card” appears in the main dis-
play, see Figure 17.
Figure 17: Searching for Card