Expansion module leds, Ethernet leds, Token ring leds – Nortel Networks Passport ARN Routers User Manual
Page 77: Expansion module leds -5, Ethernet leds -5, Token ring leds -5, Table 3-6, Expansion module ethernet leds -5, Table 3-7, Expansion module token ring leds -5
Operating the ARN
114200-E Rev 00
3-5
Expansion Module LEDs
When the ARN has an installed expansion module, its interface LEDs are visible
on the front panel. For the location of the optional ARN expansion module, see
Figure 1-4 on page 1-9.
Ethernet LEDs
describes the expansion module LEDs for the second Ethernet2
interface.
Token Ring LEDs
describes the expansion module token ring LEDs.
Note:
The ARN base module boots to a fully operational state before bringing
up expansion module interfaces.
Table 3-6.
Expansion Module Ethernet LEDs
LED
Meaning
Tx (Transmit)
Lights when the Ethernet interface is transmitting data over
the network.
Rx (Receive)
Lights when the Ethernet interface is receiving data from the
network.
Cl (Collision)
Lights when the Ethernet interface detects a collision on the
network.
Table 3-7.
Expansion Module Token Ring LEDs
LED
Meaning
RCVR (Receiver)
Lights when the token ring interface is connected to the
network.
NSRT (Insert)
Lights when you insert the ARN into the token ring network.
WFLT (Wire Fault)
Lights when the token ring hardware detects a wire fault
condition.