Nortel Networks Passport ARN Routers - Manual (Page 47)

Installing the ARN
114200-E Rev 00 1-23
Connecting a Management Console
You can use the back-panel console ports to connect one or both of the following
management devices:
• PC or terminal
• External modem or telephone connection to optional integrated V.34 modem
Using a local console, you can monitor the results of the ARN startup diagnostics
and set the boot configuration. Using an attached modem, you can enable remote
dial-in access for various management tasks.
Connecting a PC Console
To connect a PC to the ARN, you need a standard AT serial cable with a 25-pin
plug connector, plus these pieces from the ARN console/modem cable kit:
• Serial console/modem cable with 9-pin receptacle to 25-pin plug connectors
(Order No. 110307)
• Null modem crossover adapter with two 25-pin receptacle connectors
(Order No. 110308)
When you have the correct equipment, complete the following steps:
1. Configure the PC console, using the following parameters and
instructions in your PC documentation.
• Baud rate 9600
• 8 data bits
• 1 stop bit
• No parity
2. Turn off the PC.
3. Insert the 9-pin receptacle end of the console cable into the ARN Console
interface
(Figure 1-21) .
Note: To use the Netboot, Directed Netboot, or Local Boot software
configuration options described in Chapter 2, “Starting the ARN” you must
connect a management console the first time you power up the ARN.