Nortel Networks Passport ARN Routers - Manual (Page 43)

Installing the ARN
114200-E Rev 00 1-19
Figure 1-15. Connecting the FT1/T1 DSU/CSU Cable
2. Connect the other end of the cable to a T1 communications device.
Connecting to the E1/FE1 DSU/CSU Interface
You connect E1/FE1 service to the connector on an installed E1/FE1 adapter
module.
To connect to the E1/FE1 interface:
1. Insert the RJ-48C cable connector into the E1/FE1 interface
(
Figure 1-16 ).
Figure 1-16. Connecting the E1/FE1 Cable
2. Connect the other end of the cable to a FE1communications device.
ARN0065B
1
2
Tx
Rx
Cl
Tx
Rx
Cl
10BaseT
Ethernet 1
10BaseT
Ethernet 2
S/T
ISDN BRI
Compiles with FCC Rules Part 68
Reg. Number 4P8USA-31445-DE-N
Red Alm FT1/T1
DSU/CSU
Yel Alm
Loop
Sync
To
T1device
ARN0090C
1
2
ARN front panel
E1/FE1
G.703