Sharp UX-465L - Manual (Page 54)

Remote Operations
52
Comments:
♦
When a remote command is
accepted by the machine, you will
hear one beep. If an incorrect
command is entered, you will hear
four beeps. In the latter case, re-
enter the correct command.
♦
When entering a command, do not
pause longer than 10 seconds
between each digit. If you do, a 4-
beep error signal will be issued and
the digits entered up to that point
will be disregarded. In this case, re-
enter the command from the
beginning.
♦
If you make two errors (causing
two 4-beep signals to be issued)
while entering your remote code
number, the line will be
disconnected. This prevents
unauthorized people from
attempting to guess your remote
code number.
♦
If you pause for longer than 10
seconds before entering a
command, you will be
disconnected.
Changing the fax reception
mode
Select a new reception mode by
pressing the keys as follows:
•
TAD mode: "8", "1", and "#".
•
FAX mode: "8", "2", and "#".
•
TEL mode: "8", "3", and "#".
Caution: In TEL mode, you will not
be able to further change the
reception mode.
1 8
(Example)
Other remote operations
After listening to your messages, you
can do any of the operations
described below by pressing the
appropriate keys on the telephone.
Note: The following commands
cannot be entered while messages
are being played back. If you do not
want to wait until playback ends to
enter a command, first stop playback
by pressing "0" and "#", and then
enter the command.