Sharp UX-465L - Manual (Page 51)

Remote Operations
49
3. Ans
w
e
ri
ng
Machi
ne
Remote Operations
You can call the UX-465L from any touch-tone telephone and play back your
messages using the remote commands. You can also use these commands to
change the reception mode and other settings.
Remote code number
To perform remote operations, you
must first program a remote code
number. This number is used to
prevent unauthorized people from
listening to your messages or
changing the settings of your
machine.
The remote code number has been
set to "001" at the factory. If you want
to change it, press the panel keys as
shown below.
REMOTE CODE
FUNCTION 0
Press 4
times
1
Press these keys:
2
Enter a 3-digit number by pressing
the number keys.
3
Press the START/MEMORY key
and then the STOP key.
(Example)
2 2 2
START/MEMORY
STOP
Toll Saver
When you call the UX-465L to listen
to your messages, it will answer after
two rings if it has received at least
one message, or after four rings if it
has not received any messages.
This allows you to save money on
telephone charges, particularly if you
are calling long distance. If the
machine does not answer after the
second ring, you can simply hang up
before it answers, saving yourself the
cost of that call.
If you do not want to use the Toll
Saver function, you can turn it off by
following the steps below. In this
case, the UX-465L will answer after
the number of rings set in
Changing
the number of rings (see page 49),
the ring setting for FAX reception
mode.
1
Press these keys:
TOLL SAVER
FUNCTION 0
Press
twice