Sharp UX-465L - Manual (Page 53)

Remote Operations
51
3. Ans
w
e
ri
ng
Machi
ne
3
While the messages are playing,
you can do any of the following:
•
Repeat: To listen to a message a
second time, press "2" and "#" on
the telephone before that message
ends. To move back to the
previous message, press "2" and
"#" within the first 3 seconds of the
current message.
2
5
0
0 6
•
Skip forward: To skip forward to
the next message, press "5" and
"#" on the telephone.
•
Stop: To stop playback, press "0"
and "#" on the telephone. After this,
you can enter any of the
commands described in the
following section,
Other remote
operations (see page 52).
•
Play new messages: To listen to
only your new messages, first stop
playback by pressing "0" and "#",
and then press "6" and "#".
•
Erase a message: To erase the
message you are currently
listening to, press "3" and "#"
before it ends.
3
4
When you have finished listening to
your messages, you can do any of
the following:
•
Erase all messages: To erase all
of your messages, press "3", "3",
and "#".
3 3
•
Repeat playback: To listen to your
messages again, press "7" and "#".
7
•
Perform other operations: You
can enter any of the commands
described in the following section,
Other remote operations (see page
52).
•
Hang up: If you do not erase your
messages first, they will be saved
and any new messages will be
recorded after them. If you want
the UX-465L to resume normal
operation immediately, press "
* "
twice before hanging up (in some
cases, particularly when the
Transfer function is used, the UX-
465L may not accept new calls for
one or two minutes after you hang
up unless you first press "
* "
twice).