Sharp UX-465L - Manual (Page 47)

Transfer Function
45
3. Ans
w
e
ri
ng
Machi
ne
Transfer Function
The Transfer function is used to make the UX-465L automatically call you at a
specified number every time it receives an incoming message. This lets you hear
your messages immediately after they come in, even when you are at a remote
location.
When you answer the telephone, you will hear your recorded message telling you
that the call is a transfer call. Enter "#", your remote code number, and "#". The
answering machine will then play back your messages. You can also perform any of
the remote operations described in
Remote operations later in this chapter (see
page 49).
Note: When you hang up after a transfer call, the UX-465L will not immediately
resume normal operation. If you want the UX-465L to accept calls immediately after
a transfer call, enter "
* * * * " twice before hanging up (if you want to hang up during
message playback, first enter " 0" and " #" to stop playback, then enter " * * * * " twice).
Programming the transfer
number
To use the Transfer function, you
must first give the UX-465L the
number to call (the transfer number).
This is done by pressing the panel
keys as follows:
1
Press these keys:
TRANSFER # ENTRY
FUNCTION 0
Press 6
times
2
Press the START/MEMORY key.
START/MEMORY
3
Enter a transfer number (max. of 32
digits including pauses) by pressing
the number keys.
2
5
8
GHI JKL MNO
TUV WXYZ PQRS
ABC DEF
1
4
7
3
6
9
•
To insert a pause between any two
digits of the number, press
REDIAL key.
4
Press the START/MEMORY key
and then the STOP key.
START/MEMORY
STOP