Sharp UX-465L - Manual (Page 44)

Optional Answering Machine Settings
42
Optional Answering Machine Settings
Setting ICM time
Incoming messages (ICMs) are the
messages which callers leave for you
on the built-in answering machine.
The answering machine is set at the
factory to allow each caller a
maximum of 4 minutes to leave a
message. If desired, you can change
this setting to 15, 30, or 60 seconds.
1
Press these keys:
ICM RECORD TIME
2
Press a numeric key to select the
desired ICM recording time:
•
1 : 15 seconds
•
2 : 30 seconds
•
3 : 60 seconds
•
4 : 4 minutes
1
3
2
4
3
Press the STOP key.
STOP
FUNCTION 0
Press
3 times
Fax reception on TAD failure
If the memory for recording incoming
messages becomes full while you are
out, the answering machine will no
longer be able to record messages.
The ON TAD FAILURE setting is
used to choose the response of the
machine to incoming calls when this
happens:
♦
Automatic fax reception NO: The
UX-465L will answer after 20 rings,
after which it will wait to receive a
remote command. Most callers will
hang up before it answers;
however, when you call the UX-
465L from a remote location, you
can wait until it answers, listen to
your messages, and then erase
them (see
Remote Operations on
page 49).
♦
Automatic fax reception YES: The
reception mode will switch to FAX
mode, allowing the UX-465L to
continue to receive faxes
automatically. With this setting, you
can still use the remote commands
to listen to your messages and
erase the message memory (see
Remote Operations on page 52).
Automatic fax reception is set to NO
at the factory before shipping. If you
want to set it to YES, press the panel
keys as follows: